Product |
Thermal resistance
|
Properties |
Typical applications |
|
|
120 / 220 °C
(long / short term) |
• Broad range of applications
• Very good adhesion including many plastics
• Permanently elastic
• Good electric breakdown strength
• Lowest price
|
• Impregnation of microporous fittings,
castings of gear boxes and pumps, valves, wheels etc.
• Impregnation of thermally sprayed layers (metal,
ceramics etc.)
• Sealing and strengthening of rapid prototyping
models
• Adhesion promoter
• Corrosion protection |
|
|
120 / 220 °C
(long / short term) |
• As Nano-Seal 120 but for larger pores
• Meets the requirements of DIN EN 161 (pressure
tightness of gas valves) according to TÜV Rheinland. |
• Impregnation of castings with larger pores |
|
|
120 / 170 °C
(long / short term) |
• Only contains polymers which
are FDA approved
• Permanently elastic
• Very good adhesion |
• Mainlyfor the impregnation of castings (any
alloy) |
|
|
120 / 170 °C
(long / short term) |
• As Nano-Seal 120 G but for larger pores |
• Impregnation of castings with larger pores |
|
|
190 / 190 °C
(long / short term) |
• Excellent resistance to aggressive chemicals
as acids, lyes etc.
• Resistant to a large variety of solvents
• High penetration rate due to low viscosity
• Very good adhesion
|
• Sealing of thermally spayed layers for efficient
protection against corrosion
• Impregnatin of castings with very small pores
• Anti-corrosive coating of machine parts |
|
|
200 / 200 °C
(long / short term) |
• High thermal resistance
• Good general properties |
• Impregnation of castings which are subject
to high continous thermal load |
|
|
500 / 650 °C
(long / short term) |
• Extreme thermal resistance
• Highest chemical resistance (after annealing
at 220°C)
• Sole impregnation material which has to be
annealed |
• Impregnation of castings which are subject
to very high contious thermal loads
• Excellent protection of machine parts from
corrosion and aggressive chemicals
• Sealing of thermally spayed coatings which
are subject of high chemical and thermal loads or electric
discharge (rolls aunder corona) |
Product
(Water-borne) |
Thermal resistance |
Properties |
Typical applications |
|
|
180 / 200 °C
(long / short term) |
• Water dilutable
• No labeling as hazardous good required
• Environmentally friendly, almost odour-free
• Excellent adhesion on metals an a great variety
of plastics
• Highest polymer contents
• Nanoparticles ensure excellent penetration
• Meets the requirements of DIN EN 161 (pressure
tightness of gas valves) according to TÜV Rheinland.
|
• Impregnation of castings
• Sealing and strengthening of rapid prototyping
models (in particular those which are not resistant
to solvents) and for "office use"
• Sealing of thermally sprayed layers |
